Should i Get Cylinder head ported? - Team-2G Mitsubishi Forum

DSMeclipseGST · 08-04-2009, 02:01 PM

Well this is a thing thats been eating at me im bout to take my head to the shop and get it machined and was thinking about getting it ported but i am still useing the *sarcasticly* good ole T-25 should i go ahead and port it or just wait till i get more internals like i plan on?

fastmitsu18 · 08-09-2009, 06:50 PM

I say, if it's already off, port it.

bigfred · 01-02-2010, 09:46 PM

Port it since you are going to have it off and have them blend the bowls. It will increase the air flow that enters the head.

G-booS-T · 02-03-2010, 01:18 AM

Port and polish while its off. Make sure you bring them both intake and exhaust manifolds so they can port match em. That's whats most important.

08-04-2009, 02:01 PM	#1
DSMeclipseGST Member Join Date: Apr 2009 Location: Monroe Posts: 61	Should i Get Cylinder head ported? Well this is a thing thats been eating at me im bout to take my head to the shop and get it machined and was thinking about getting it ported but i am still useing the sarcasticly good ole T-25 should i go ahead and port it or just wait till i get more internals like i plan on?

01-02-2010, 09:46 PM	#3
bigfred New Member Join Date: Apr 2006 Location: Bristol Posts: 48	Port it since you are going to have it off and have them blend the bowls. It will increase the air flow that enters the head. __________________ evoIII 16G, apexi neo, pte 550cc, walbro 190lph, apexi gt downpipe, apexi n1 catback, hks bov, injen intake, upper intercooler pipe, palm datalogger, autometer boost/vaccum, egt, wideband a/f, greddy profec b spec II boost controller(10psi), ngk 1 step colder plugs, apexi front mount intercooler with piping

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
cylinder head won't come off	iNOS_dragRacer	General/Troubleshooting	9	03-13-2007 10:18 PM
EVO cylinder head	DSM1998GST	Turbocharger and Nitrous	3	08-04-2006 04:37 AM
Cylinder Head	96dodgeavenger	Performance Engine/Bolt-ons	10	11-15-2005 02:45 PM
WTB Cylinder Head	GGGSSSSXXXXX	Want To Buy	2	09-14-2005 01:08 AM
FS: 1G head ported and polished	nomoredsm	Want To Buy	0	12-05-2004 08:09 PM

08-09-2009, 06:50 PM	#2
fastmitsu18 Member Join Date: Jul 2009 Location: Lancaster, CA Posts: 64	I say, if it's already off, port it.

02-03-2010, 01:18 AM	#4
G-booS-T New Member Join Date: Jan 2007 Location: Windsor, CT Posts: 9	Port and polish while its off. Make sure you bring them both intake and exhaust manifolds so they can port match em. That's whats most important.