how do i remove the door moulding - Team-2G Mitsubishi Forum

Red Terror · 04-24-2008, 10:46 AM

I'm taking the ground effects on my GST and I can't figure out how the door piece is on there. I figured I'd ask before I started pulling @ it. I searched around & looked in my Chilton manual and came up with nothing.

zappa26 · 04-24-2008, 11:50 AM

Hopefully you're not replacing them with a shitty rice kit, but to each his own.

Anyways, they're just on there with little clips, and some sort of glue around the edges. On mine all the glue came loose though so it was just the clips holding it on.

So, you can just grab a flathead screwdriver and just pry the edges off off, being careful not to scratch your paint job. Then the little clips will pull out really easy.

Red Terror · 04-24-2008, 12:50 PM

No, I'm not ricing it out lol. 2g's are sexy the way they are. Actualy, I'm parting it out & I need to get them pieces off without damaging them.

SJ Is Here · 07-16-2008, 08:57 PM

got any pics? :D I would just follow it to its mounting point....