Quote:
Originally Posted by a scaryy bear
Thats what I was thinking.
But I have no remote for it or anything and Im not sure if I can program another one?
or even find out if I have one installed.
not sure if this has anything to do with it but the head unit says code on it and i read about it and some people say its for the alarm.
so im not to sure.
How can I tell if its hooked up/program new remote?
|
1) Yes you can reprogram the remotes,
To reprogram your keyless entry system for a new key fob:
1) Turn ignition to OFF.
2) Ground pin 1 of the Data Link Connector (black 16-pin connector under dash driver's side). Pin 4 of this connector is a ground, so placing a jumper wire between pins 1 & 4 will accomplish this. Grounding pin 1 tells the system you are getting ready to reprogram it.
3) Close all the doors.
4) Turn the key to ACC, then back to OFF. The power locks will lock/unlock. The system is now ready to be programmed.
5) Press a button on your key fob.
6) If you have two key fobs, press a button on the second fob within 1 minute of pressing a button on the first one. Both must be programmed at the same time. If you only have one remote, press a button on it 2 more times to signal that you only have one.
7) The doors will lock/unlock to signal that the codes were received.
8) Remove the connection between pins 1 & 4.
2)When the stereo says code, it is an anti theft feature, you need the 4 digit code to use it, I hope you have it. I usually does this when your car looses power.
Linear Mode
